CONTROL STAND / THRUST LEVER QUADRANT DIMENSIONS
TOP LENGTH
• approximate length mm • 315 mm at top of the Control Quadrant ( about level with the SpeedBrake Lever )
• 320 mm at top of the Control Quadrant ( about level with the lower FMC panel )
BOTTOM LENGTH
• approximate length mm • 480 mm at lower section of the Control Quadrant
( about 80mm above floor level with Rudder Pedal Floor )
• approximate length mm • 380 mm at floor section of the Control Quadrant
• approximate length mm • 320 mm at floor section of the Control Quadrant
( same as top length if you exclude forward slope towards FMC CDU )
WIDTH
• approximate width mm • 235 mm
HEIGHT
• approximate height mm • 480 mm
STABILISER TRIM WHEELS
• approximate Diameter 230 mm
• approximate Thickness 30 mm
• approximate Axel position from fwd edge 165 mm
from aft edge 150 mm
from top 45 mm
from base 435 mm
SPEEDBRAKE LEVER
• approximate Length 155 mm = 100 Shaft + 55 Handle
• approximate Thickness 25 mm RIM
15 mm Inner wheel
• approximate Position
Down from fwd edge of Control Quad box 15 mm
Flight from fwd edge of Control Quad box 150 mm
Full Up from fwd edge of Control Quad box 180 mm
THRUST LEVER
• approximate Height 185 mm
• approximate Depth 60 mm
• approximate Width xx mm ?
• approximate Lever Position
FULL level with the SpeedBrake Lever down position
MID level with the Flap Lever 2 position
CLOSE level with the Flap Lever 15-25 position
FLAP LEVER
• approximate Height xx mm ?
• approximate Width xx mm ?
PARKING BRAKE LEVER
• approximate Height xx mm ?
• approximate Width xx mm ?
START LEVER
• approximate Height xx mm ?
• approximate Width xx mm ?
START LEVERS
• approximate panel Height XX mm
• approximate panel Width XX mm
STAB TRIM CUTOUT
• approximate panel Height 65 mm
• approximate panel Width 85 mm